Case 1: USNIP OFF

Multiple MIPs in same or different subnet

NetScaler will use all the MIPs to establish connections to backend servers in round robin fashion.

You can use “nsapimgr -ys miproundrobin=0” command on shell prompt to stop this behavior

Using this command will make use of 2nd MIP only after 1st MIP is exhausted with all ports.

Note: Please use nsapimgr commands with utmost care and with out any typos

Case 2: USNIP ON

Case 2.a) SNIPs Only

NetScaler will use all the appropriate SNIPs to establish connections to backend servers in round robin fashion. This behavior can not be changed.

Case 2.b) : MIPs and SNIPs

NetScaler will use the appropriate IP (Can be MIP or SNIP) to establish connections to backend servers in round robin fashion. This behavior can not be changed